Probador de transistores

Aquí está el circuito de un probador de transistores muy simple que utiliza dos LED para mostrar el estado de un transistor. Both PNP as well as NPN transistors can be tested using this circuit. Tanto la PNP, así como los transistores NPN se puede probar con este circuito. Quad 2 input CMOS NAND gate IC CD4011B is the heart of the circuit. Cuadrángulo 2 NAND la puerta de entrada CMOS IC CD4011B es el corazón del circuito. Out of the four NAND gates inside the IC, only three are used here and they are used as NOT gates by shorting their input terminals. De las cuatro puertas NAND dentro de la IC, sólo tres se utilizan aquí y se utilizan como puertas NO por un cortocircuito en sus terminales de entrada. Gates U1a, U1b, resistor R1 and capacitor C1 forms a square wave oscillator. Gates U1a, U1b, la resistencia R1 y el condensador C1 forma un oscilador de onda cuadrada. The frequency of this oscillator can be adjusted by using R1. La frecuencia de este oscilador se puede ajustar mediante el uso de R1. The output of the oscillator is inverted using the gate U1c. La salida del oscilador se invierte con la puerta U1c. The inverted oscillator output is connected to the base of the transistor under test through the resistor R2 and the non inverted oscillator output is connected to the emitter of the transistor under test using the resistor R3. La salida del oscilador invertido está conectado a la base del transistor bajo prueba a través de la resistencia R2 y la no salida invertida oscilador está conectado con el emisor del transistor bajo prueba con la resistencia R3.
The status of the LEDs D1 and D2 reveals the condition of the transistor under test. El estado de los LEDs D1 y D2 revela la condición del transistor bajo prueba. If red LED is ON, It indicates that the transistor under test is a good NPN. Si el LED rojo está encendido, indica que el transistor bajo prueba es una buena NPN. If green LED is ON, it indicates that the transistor under test is a good PNP. Si el LED verde está encendido, indica que el transistor bajo prueba es una buena PNP. If both LEDs are ON, it indicates that the transistor under test is short. Si ambos LED están encendidos, esto indica que el transistor bajo prueba es corto. If both LEDs are OFF, it indicates that either the transistor is bad or you may have connected it incorrectly. Si ambos LED están apagados, que indica que el transistor es malo o es posible que la ha conectado incorrectamente.
Circuit diagram. Diagrama de circuito.
LED based transistor tester circuit
Notes. Notas.
  • The circuit can be easily assembled on a Vero board. El circuito se puede montar fácilmente en un tablero de Vero.
  • Use 5V DC for powering the circuit. Utilice 5V CC para alimentar el circuito.
  • All unused pins of the IC must be connected to ground. Todos los pines no utilizados en el CI debe estar conectado a tierra.